Due to their eco-friendliness, water resistance, and ease of installation, Wood-Plastic Composite (WPC) doors-such as those from Xinhongyuan-have seen widespread use in residential interior design. Their installation process is significantly more efficient than that of traditional wooden doors, largely thanks to a "quick-install" structural design. The door frame and casing (trim) utilize a snap-fit connection, eliminating the need for pneumatic nails or adhesives, which greatly accelerates the construction process.
Standard Installation Procedure for WPC Doors
Preparation and Inspection
Verify that the dimensions of the door opening match the door leaf, and ensure the wall is sturdy and level.
Check the contents of the packaging to ensure all components-door leaf, frame, casing, and hardware-are present and undamaged.
Prepare the necessary tools: rotary hammer, spirit level (a laser level is preferred), tape measure, screwdriver, wooden wedges, and polyurethane expanding foam.
Assembly and Positioning of the Door Frame
Connect the vertical and horizontal frame components according to their labels, securing them into a complete frame using connecting brackets.
Mark vertical and horizontal reference lines within the door opening to ensure accurate positioning.
Place the assembled frame into the opening, secure it temporarily with wooden wedges, and use a spirit level to ensure it is perfectly vertical.
Securing the Frame and Applying Foam
Once the frame is confirmed to be vertical, apply polyurethane expanding foam along the hinge side and the top to enhance stability, provide sound insulation, and improve thermal insulation.
Secure the frame firmly to the wall using expansion bolts or specialized mounting brackets, with at least three fixing points on each side.
After the foam has cured (typically requiring 24 hours), trim away any excess foam to ensure a smooth, flush surface.
Installation of the Door Leaf
Attach the hinges to the door leaf, then hang the door leaf onto the hinges mounted on the door frame.
Adjust the gaps between the door leaf and the frame-2–3 mm at the top, 2.5–4 mm on the sides, and 6–8 mm at the bottom-ensuring they are uniform.
Test the door to ensure it opens and closes smoothly, without any friction or sticking. Installation of Door Casing and Decorative Trim
Utilize a snap-fit design: insert the door casing directly into the pre-cut grooves on the door frame-no nails or adhesive required.
For corners, miter-cut the trim at a 45° angle to ensure a clean, aesthetic finish.
Once installed, apply a small amount of sealant to the gap between the door casing and the wall to provide a neat edge.
Installation and Adjustment of Hardware
Install hardware components such as door locks, door stops, and handles; the lock is typically positioned 90–100 cm above the floor.
After installation, perform thorough testing: ensure the latch bolt extends and retracts smoothly, the door stop effectively secures the door panel, and the handle springs back responsively.
Finally, remove any wooden wedges, complete the cleanup, and conduct a final inspection.

